I'm using ActiveHome to control my X-10 modules in the house. I just
installed a signal coupler and am now finally able to control the entire
house but I'm having a problem programming macros on Active Home. I would
like to have one macro turn on several different lamp & appliance modules at
dusk and I programmed it accordingly, but nothing happens. If I program
each module individually they all work, but not with the macro. Any hints
or ideas?
I had ActiveHome for a short period of time before upgrading to Homeseer. Its definately worth the investment and there are tons of support forums/resources available on the web for programming/troubleshooting etc.
The MyLounge.com forum is intended for informational use only and should not
be relied upon and is not a substitute for any advice. The information contained
on MyLounge.com are opinions and suggestions of members and is not a representation
of the opinions of MyLounge.com. MyLounge.com does not warrant or vouch for
the accuracy, completeness or usefulness of any postings or the qualifications
of any person responding. Please consult a expert or seek the services of an
attorney in your area for more accuracy on your specific situation. Please note
that our forums also serve as mirrors to Usenet newsgroups. Many posts you see
on our forums are made by newsgroup users who may not be members of MyLounge.com
Term of Service
Active Home & X-10
Linear Mode
